What you need: An empty can of Pringles potato chips, two latex rubber gloves, two foam sponges, two electrical-cable ties, and lube. Cut off all the fingers of one of the gloves but not the thumb, leaving a latex tube. Tie a knot in the glove's wrist. Next, cut a couple of parallel slots in the Pringles lid near the middle to thread a cable tie through. Tie knots in all the other glove's fingers except for the middle finger. Secure this middle finger to the inside of the lid using the cable tie. You now have a latex sleeve to simulate the inside of a vagina. Now you need to mold the sponges to surround the glove – it's up to you how tight you want to make it. Cut off the bottom of the Pringles can, leaving a hollow tube. Slide the glove and sponge arrangement into the tube and secure the lid. Now stretch the glove's wrist over the open end of the tube, and finally, stretch the other glove over the entrance and secure it with a cable tie. Add liberal amounts of your favorite lube, and there you have it – your very own "vagina" that you can shag whenever you want.
Bringing JackinWorld where it is today cost me over $8000 last year alone. It's more than I can afford right now. Would you help us keep the site safe, with no viruses, spyware or trojans, and free of advertising by please considering sending in a donation of $5, $10, $20, $50, $100, $250, or whatever you can reasonably afford. You can also easily donate via credit card by using PayPal. We can either keep you anonymous or acknowledge your donation on our Donate page. Thank you!
If you're straight and use gay porn, how would you feel if someone found it?
Answer this question | Suggest a question
Answer this question | Suggest a question
Pringles-can Simulator
