Pringles-can Simulator: Comments

Add new comment


No offense to anyone, but most of these ways to create a pussy on here seem pretty involved for sub par results. I would recommend getting a straightforward and commercially made product. Best money I ever spent. Worst money was spent on a commercial product that was supposed to simulate a blow job, despite all the great reviews on their site, unless you have a very sensitive cock or cum quick I would stay away from this one. Good concept and much better quality construction than a pocket pussy but still needs improvements.

seems like in the amount of time it takes to make a pringle vagina you could work on a relationship with a real girl

Its also easy to wrap a bunch of dish towels tightly and put a plastic wrap tube in the middle. Lube the tube and run hot water into the pringles can soaking the dishrags. Actually kinda feels like a pussy if you use the right plastic wrap and lube.

could someone show a picture of one mad or something. this just seems hard for me to do with out seeing how it should look.

For all this trouble, you could just buy a Flesh Light or something similar. Or, you know, go find a real woman to "shag", if you're craving the feel of a vagina that much.

hey the Pringles can has always been the best thing for masturbation in my opinion, for anyone thinking about it there are several things u can also make with the can such as taking a warm blanket and placing it flat over the opening of the can, then with ur fingers shove the blanket as far in as possible so that there is a small opening in the can IT RESEMBLES A REAL VAGINA .its perfect for those who don't have much to work with and want something fast...(for a better feeling find a really soft blanket...a quilt is best because of how thick it is, makes for a tighter hole)

I found this "toy" very interesting because materials happened to be readily available. However, having read the instructions several times- I found the whole thing really difficult to relate/understand. What I ended up with were several bizarre variations of something looking like modern art (not much luck on the sim side). Whilst I appreciate the time it would take & drain on site resources, I wish there were photos or drawings to accompany this... unfortunately, I just dont get it. Hoping I'm not the only one? Not being faceitious on purpose but: if you cut the fingers off a latex glove leaving the thumb, it doesnt leave a "tube" - it leaves a weird glove with 4 cut off fingers & a thumb socket vearing off at 45 degrees (?)

I find the part about the second glove stretched over the entrance to be very confusing. If it is stretched over the entrance, how do you get your penis in?
Below I have edited the instructions to be clearer. Could someone explain what should be done with Glove 2? I assume I have it wrong below.
Also, it doesn't seem like the cable tie will hold the middle finger of Glove 1 in place.
What you need:
One empty Pringles potato chip can
Two latex rubber gloves
Two foam sponges
Two electrical-cable ties
Lube.
Lid: Cut a couple of parallel slots in the Pringles lid near the middle to thread a cable tie through. Can: Cut off the bottom of the can, leaving a hollow tube. Glove 1: Tie knots in all fingers except for the middle finger. Secure this middle finger to the inside of the lid using the cable tie. You now have a latex sleeve to simulate the inside of a vagina. Sponges: Trim the sponges to fit inside the can and to surround Glove 1 — it's up to you how tight you want to make it. Slide the glove and sponge arrangement into the tube and secure the lid. Stretch Glove 1's wrist over the open end of the tube. Glove 2: Cut off all the fingers, but not the thumb, leaving a latex tube. Tie a knot in the glove's wrist. Stretch Glove 2 over the entrance and secure it with a cable tie. Add liberal amounts of your favorite lube, and there you have it — your very own "vagina" that you can shag whenever you want.

this is so good